Mugen Seiki Fuel Tank w/Clunk
Related Products
Mugen Seiki Rear Shock Boot (4)
€12.49
This is a pack of four replacement Mugen Rear Shock Boots, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy. Because these updated boots fit very tight on the shock shaft, it is recommended to install these boots before installing the shock end. Trying to stretch the boot over the shock end may rip the boot.
Mugen Seiki Front Shock Boot (4)
€12.49
This is a pack of four replacement Mugen Front Shock Boots, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy. Because these updated boots fit very tight on the shock shaft, it is recommended to install these boots before installing the shock end. Trying to stretch the boot over the shock end may rip the boot.
Mugen Seiki Damper Cap Bushing (4)
€6.90
This is a set of four replacement Mugen Damper Cap Bushings, and are intended for use with the Mugen MBX6 family of 1/8 Scale vehicles.
Mugen Seiki MBX7 Air Filter (4)
€22.90
This is a pack of four replacement Mugen Air Filters, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy. These air filters are dry and require oiling.
Mugen Seiki Front Lower Suspension Arm Set
€12.50
This is a replacement Mugen Front Lower Suspension Arm Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy. This set includes a left and right side lower arm.
Mugen Seiki Front Bumper
Mugen Seiki Front Bumper
€8.40
This is a replacement front bumper for the Mugen MBX7 family of buggies. This is the updated version . The front bumper is now reinforced.
Mugen Seiki Damper Mount (4)
Mugen Seiki Damper Mount (4)
€13.90
This is a set of four replacement Mugen Damper Mounts, and are intended for use with the Mugen MBX6 family of 1/8 scale vehicles.
Mugen Seiki Oil Seal Set (16)
€12.90
This is a pack of sixteen replacement oil shock seals, that are used to rebuild the shocks. These seals form the seal at the end of the shock body between the shock body and the shock shafts. If the seals are old and worn out, the shocks will leak oil so it is always a good idea to change the seals periodically.
Mugen Seiki Gear Box
Mugen Seiki Gear Box
€17.90
This is a replacement Mugen gear box, and is intended for use with the Mugen MBX7 and MBX7T 1/8 scale vehicles.
Mugen Seiki Complete Bushing Set
€13.90
This is a replacement Mugen Complete Bushing Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy. This complete set includes all of bushings used in the suspension mounts to adjust toe angle, kick-up and anti-squat on the vehicle.
Mugen Seiki Aluminum Clutch Shoes (3) (Hard)
€34.90
This is a set of three Mugen "Hard" Aluminum Clutch Shoes and are intended for use with the Mugen family of 1/8 scale vehicles or any other vehicle using a Mugen flywheel. This new clutch shoe is made from a harder aluminum than the standard C0754 shoe, providing longer life and another clutch tuning option.
Mugen Seiki 8x16x5mm Bearing (10)
€24.90
This is a pack of ten replacement 8x16x5mm Rubber Sealed Ball Bearings for the Mugen MBX buggy and MBX truggy. These are the bearings used for the diff outdrives, bevel gears and hub carrier assemblies..
