THE 7mm Ball for Upper Link
THE Airfilter Foam Inner and Outer 4pcs
THE JQRacing Air Filter Foam Set includes four inner air filters, and four outer air filters.
THE Shock Boots
THE JQRacing Shock Boot Set include 4pcs, to be used on the front or rear shocks. These shock boots are installed over the shock shafts and are held in place by a groove in the shock body and the lower spring cup. They are used to protect the shock shaft and shock seals from dirt and debris. They also work as bump stops, reducing the jolt as t...
THE JQRacing Bumpers include the front and rear bumpers for THECar.
THE 7075 Black Clutch Shoes with springs, 3pcs for 3-shoe clutch
THE JQRacing 7075 Black Clutch Shoes with springs, 3pcs for 3-shoe clutch
THE Inner Hingepins. 61.5mm Front 64.5mm Rear
THE JQRacing Front/Rear Inner Hinge Pin Set includes two front and two rear hingepins. The hinge pins are installed in the suspension arms and secured by the hinge pin blocks, providing pivot points that allow the suspension to work.
THE Shock Bushings
THE JQRacing Shock Bushing Set includes the two small guide bushings that are installed between the o-rings, as well as two lower shock shaft guide bushings, enough to replace the bushings on two shocks.
THE Bearing 8x16x5 4pcs. For Wheels and Differentials
THE JQRacing 8×16×5mm Bearing Set includes four bearings. These bearings are used to support the differentials, and wheel axles. This is the most best and most durable size for 1:8th buggies.
THE 110mm Centre Dogbone, Stock Weight Front
THE JQRacing 110mm Center Dogbone, for the rear, with the centre diff set in the mid to front positions.
THE Diff Gasket
THE JQRacing Differential Gasket Set includes 3pcs of the paper gaskets, enough for all three diffs. These gaskets are installed in between the ring, or spur gears, and the differential cups. They are the component that seals the differentials at the ring/spur gear. This package includes three differential gaskets.
THE Clutchbell bearings 5x10x4mm 10pcs
THE JQRacing 5×10×4mm Clutch Bearing Set includes 10pcs bearings. These bearings can be used in any application that requires a 5×10mm bearing, clutchbells, and 1:10th cars for example.
THE 86mm Centre Dogbone, Stock Weight Front
THE JQRacing 86mm Center Dogbone, for the front, with the centre diff set in the mid to front positions.
THE 13t Clutchbell with 2pcs 5x10 bearing
THE JQRacing 13 Tooth Clutch Bell includes one 13 tooth clutch bell, and two 5×10mm bearings. This is the standard clutchbell for THECar.